Electroguard E30® Anti Static Paint
Electroguard E30 is a Two-Pack Water Based, Static Dissipative Polyurethane paint. It offers an inexpensive yet high specification means of protecting sensitive areas from the costly effects of static build up and provides a means of grounding personnel.
Electroguard E30 is easily applied and maintained and consists of two components, pre-measured for convenience. It should not be confused with more expensive multi coat systems which require installation by specialist contractors and which fail to meet specification with wear. The paint can be applied by brush or roller and the equipment may be cleaned after use in warm water.
Electroguard E30 has excellent chemical resistance, can be easily cleaned and as a Polyurethane Paint it can withstand very heavy traffic wear. The paint has an attractive satin finish and is available in Grey, nearest to RAL 7004
Ready to find out more?
If you are interested in Electroguard E30® Anti Static Paint please get in touch and we'll be happy to help.
|Coverage:||9m² per litre, 45m² per tin, one coat (we recommend 2 coats)|
|Pack Size:||5 litres|
|Drying Time @ 20°C:||Touch Dry 3hrs
Re-Coat at 16 hrs
Full Cure 3 days
|Colours:||Grey RAL 7004|
|Mix Ratio:||Base / Activator supplied in correct ratio
Base 4 parts : Activator 1 part
Do not thin
|Transportation:||No transport/hazard issues|
|Typical Thickness:||40 microns per coat, two thin layers. Do not over apply thickness|
Two coats are recommended for best results and should be applied over a sound, sealed floor, free from dirt, oil or any loose particles. It is strongly recommended that E30 not be applied over bare surfaces, concrete, wood, tiles, plasterboard etc. Where this occurs a Water Based Primer should be first applied.
We advise against applying if the temperature is below 10°C or if the Moisture Content of the concrete surface to be applied over is greater than 15%. Curing times are dependent on temperature, humidity and ventilation.
Electroguard E30 is a highly durable paint and is designed to be used in high traffic areas such as factory floors, warehouses, corridors etc. It is designed to withstand wear from people, pallet and fork lift trucks. Two coats of E30 applied evenly over a sealed floor will offer many years of protection against static build up.
Surface Resistance: 10(5)-10(8) Ohms/Square
Resistance to Ground: 10(5)-10(8) Ohms
Conforms to IEC 61340-5-1/2
Charge Decay: Conforms to MILB81705C